Is Leak-B-Gone Near Me?

Leak-B-Gone is designed to stop leaks that have occurred at the pipe joint. It can not stop leaks that have occurred elsewhere on the pipe or on a compression fitting such as those found in bathrooms or kitchen “P-Traps”.

When installing Leak-B-Gone, it is important to install it correctly. This includes using the correct size ring and properly latching it during installation.

How to Install Leak-B-Gone

King Innovation’s Leak-B-Gone ring is a permanent solution to leaking PVC pipe joints and can be installed in as little as 60 seconds without any tools. This leak stopper ring will save contractors hundreds of dollars and hours of time by eliminating the need to cut out and replace sections of leaking pipe.

It is important that the leaking pipe diameter be accurately measured and matched to the Leak-B-Gone ring size chart (shown below) before installation. If the ring is not the correct size, it may become prematurely stuck to the pipe and WILL NOT stop the leak!

What Size Leak-B-Gone Should I Use?

Leak-B-Gone is available for seven different sizes of PVC pipe. The ring should be sized according to the size of the pipe on which it is being installed. The ring should be installed on a clean pipe, free of any residue, glue or mud around the leak. It is important that the ring is latched away from the glue so that it does not become stuck to the pipe, preventing it from properly stopping the leak. Find a wide variety of Leak-B-Gone from King Innovation here at HomElectrical! ***Please note that changing fulfilment methods might impact delivery time.

Installation Away from Glue

If the Leak-B-Gone ring is installed too close to the glue, it may become prematurely stuck to the glue and will not stop your leak. The ring should be latched away from the glue and towards the pipe fitting/leak. Additionally, the ring should be latched onto a clean pipe. If the pipe has residue or mud on it, it will not adhere properly and will not be effective. Therefore, it is important to install the ring on a clean pipe that has been primed and latched with PVC glue.

Installation on a Clean Pipe

Leak-B-Gone should only be installed on a pipe that has been cleaned. If there is buildup of residue, glue, mud, or other materials on the surface of the pipe then it will not adhere to the PVC cement and may not stop your leak.

The Leak-B-Gone ring from King Innovation is designed to permanently repair leaking PVC pipe joints in as little as 60 seconds with no tools required! Easily find your perfect size and install to enjoy an airtight, waterproof seal around your leaky pipe joints. You won’t regret it!

Installation on a Dry Pipe

King Innovation’s Leak-B-Gone is a quick and easy-to-install solution for PVC leaks. It can be installed in as little as 60 seconds and requires no tools!

Before installing the ring, it’s important to dry off the leaking area. This will ensure that the cement adheres properly. Once the ring is latched, it will seal the leak and prevent water from escaping.

It’s also essential to install the ring on a clean pipe. If the pipe already has residue, glue, mud, etc., then it may not be able to latch or adhere properly.

Stay on the page to know more